There are a few reasons why your transmission may not be working when it’s hot. The most common reason is that the fluid has become too thin and needs to be replaced. Another possibility is that there is something blocking the flow of fluid, such as a clogged filter. Alternatively, the problem could be with … Read more
If the transmission friction element is stuck on your Ford Focus, it may be due to a variety of factors. The most common cause is low fluid levels, which can cause the clutch to engage prematurely and wear down the friction material. Other causes include a dirty or damaged filter, incorrect fluid type, or a … Read more
When the transmission control system mil request is turned on, there are a few things that can be done to fix it. The most common thing to do is to check the fluid levels and make sure they are full. If the fluid levels are low, then adding more fluid will usually fix the problem. … Read more
There is no definitive answer to this question as it depends on the make and model of the vehicle, as well as the driving conditions. However, generally speaking, if there is more than a quart of metal in the transmission fluid, it is likely too much and could indicate a serious problem. If you are … Read more
In short, no – it does not matter which transmission line goes where. However, there are some factors to consider when determining the best configuration for your particular situation. The most important factor is impedance matching. If the impedances of the transmission lines do not match, then reflections will occur and signal integrity will be … Read more
If the automatic transmission won’t go into gear after a fluid change, the most likely cause is that the wrong type of fluid was used. The best way to avoid this problem is to use the type of fluid specified by the manufacturer. If you’re not sure what type of fluid to use, ask a … Read more
If you notice air bubbles in your transmission fluid, it’s important to take your car to a mechanic as soon as possible. Air bubbles can cause the transmission to overheat and fail. The mechanic will check for leaks in the system and repair or replace any damaged parts. If you notice air bubbles in your … Read more
There are a few things that could be causing your 4L60E transmission to shift hard from 1st to 2nd gear. It could be low fluid levels, dirty fluid, or a problem with the shift solenoids. If you suspect low fluid levels, check the dipstick and add more fluid as needed. If the fluid looks dirty, … Read more
